skip to navigation
skip to content

autocloudreporter 1.0.3

Fedmsg consumer to report Autocloud results to ResultsDB

autocloudreporter is a fedmsg consumer for reporting Autocloud results to ResultsDB. It listens out for Autocloud fedmsg messages, and submits results using the resultsdb_conventions module for conveniently reporting results in ‘conventional’ format.

The code was written with Python 3 in mind, but it turns out that verification of fedmsg message signatures does not currently work in Python 3, so it should be run under Python 2 for now.

Requirements

Python libraries:

Installation

Install the required external Python libraries, then use setuptools to install, e.g.:

python setup.py install

Test and production modes

Two consumers are provided, a ‘test’ and a ‘production’ consumer. For ‘test’:

  • The consumer listens for dev (not prod) messages
  • The consumer does not validate message signatures
  • The consumer reports to a ResultsDB instance running on localhost port 5001

In this mode it is safe to play around with the consumer, and you can use a tool like fedmsg-dg-replay to trigger event creation by replaying a relevant fedmsg (which will show up with a dev topic rather than prod).

For ‘production’:

  • The consumer listens for prod (not dev) messages
  • The consumer validates message signatures
  • The consumer reports to the production ResultsDB instance (if permitted)

PLEASE do not enable the production consumer on a system authorized to submit results to ResultsDB without checking with Fedora QA.

The fedmsg config keys for the consumers are autocloudreporter.test.enabled and autocloudreporter.prod.enabled respectively.

License

autocloudreporter is released under the GPL, version 3 or later. See COPYING and the header of autocloudreporter.py itself.

 
File Type Py Version Uploaded on Size
autocloudreporter-1.0.3.tar.gz (md5) Source 2017-02-17 20KB