skip to navigation
skip to content

automated-ebs-snapshots 0.2.1

Automatic backup management of AWS EC2 EBS volumes

Latest Version: 0.5.0

Automated EBS Snapshots helps you ensure that you have up to date snapshots of your EBS volumes.

All you need to do to get started is documented below.


pip install automated-ebs-snapshots

Authentication configuration

Automated EBS snapshots can be configured either via command line options or via command line options.

Command line options

You can use the following command line options to authenticate to AWS.

AWS configuration options:
  --access-key-id ACCESS_KEY_ID
                        AWS access key
  --secret-access-key SECRET_ACCESS_KEY
                        AWS secret access key
  --region REGION       AWS region

Configuration file

Create a configuration file anywhere on you file system.

access-key-id: xxxx
secret-access-key: xxxxxxxx
region: eu-west-1

Then use the --config command line option to point at your configuration file.

Watching and unwatching volumes

Start watching a volume

In order to enable automatic snapshots, you need to start watching the volume. The following command will add vol-13245678 to the watchlist with snapshots created daily.

automated-ebs-snapshots --config ~/auto-ebs-snapshots.conf --watch vol-12345678 --interval daily

List watched volumes

List the currently watched volumes and their backup interval

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --list

Stop watching a volume

To stop creating automated backups for a volume, run this:

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --unwatch vol-12345678

Creating snapshots

Now, to start taking snapshots you will need to have Automated EBS Snapshots running. You can either run automated-ebs-snapshots manually (i.e. scheduled in crontab or such) or have it running in daemon mode.

Manual execution

Running automated-ebs-snapshots manually:

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --run

It will check if there are any volumes with no or too old snapshots. New snapshots will be created if needed.

Daemon mode

Start the daemon by running

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --deamon start

Stop the daemon with

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --deamon stop

You can also restart it using

automated-ebs-snapshots --config ~/automated-ebs-snapshots.conf --deamon restart


This project is maintained by Sebastian Dahlgren and it is supported by Skymill Solutions.


APACHE LICENSE 2.0 Copyright 2014 Skymill Solutions

Licensed under the Apache License, Version 2.0 (the “License”); you may not use this file except in compliance with the License. You may obtain a copy of the License at

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an “AS IS” BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

File Type Py Version Uploaded on Size
automated-ebs-snapshots-0.2.1.tar.gz (md5) Source 2014-04-28 18KB