box0 0.1.0

pyBox0
======

Python binding for libbox0

Dependencies
============

* cffi
* numpy

In C:

* libbox0
* libusb

Installation
============

$ python setup.py build
$ python setup.py install

Configuration
=============
in local.properties
_binding.py, build_path variable to tell where to look for header and library

Usage
=====

lots of demo code in test/ and example/
a generic approch to opening device and module and do something with them

import box0

# open any supported usb device
dev = box0.usb.open_supported()

# open the gpio0 module (assuming the device support it)
# if you need to iterate over the supported modules using dev
gpio0 = dev.gpio(0)

# set to output mode
gpio0.dir(0, gpio0.OUTPUT)

# set value of pin 0
gpio0.value(0, gpio0.LOW)

#disable hiz mode of pin 0,
# note: all pins are in hiz mode right after opening (for protection)
gpio0.hiz(0, gpio0.DISABLE)

// wait
try:
while True:
time.sleep(.5)
except:
pass

# close resources
gpio0.close()
dev.close()

Note
====
pyBox0 uses same style as libbox0 and
much of the documentation of libbox0 is applicable to pyBox0

int b0_<section>_<func>(<section-object>, params....)

in pyBox0:
instead of int, an exception (ResultException is raised) when int-val < 0
so, now the return value is used for other tasks

"b0" tag is now replace with "box0." as python have concept of modules

<section> is replace with files.
for example: <section> = "device" , theirs device.py
and it contain Device.py


<func> these are under-scored style name in libbox0
in pyBox0, camelcasing is used
for example b0_usb_open_supported() is box0.usb.openSupported()

most of the library assumes numpy array.
numpy is good and you should always use numpy with pyBox0 as
it much better in long run

Getting help
============

get on to #box0 on IRC freenode
and report bug on https://gitlab.com/madresistor/pyBox0

Getting involved
================

get on to #box0 on IRC freenode
and report bug on https://gitlab.com/madresistor/pyBox0

Licence
=======

GNU/GPLv3 or later (see COPYING)

Credits and references
======================

http://www.madresistor.org/

Maintainer
==========

Kuldeep Singh Dhaka <kuldeepdhaka9@gmail.com>