skip to navigation
skip to content

Not Logged In

os-refresh-config 0.1.0

Refresh system configuration

Latest Version: 0.1.2

os-refresh-config uses dib-run-parts to run scripts in a pre-defined set of directories:

/opt/stack/os-config-refresh/pre-configure.d
/opt/stack/os-config-refresh/configure.d
/opt/stack/os-config-refresh/post-configure.d
/opt/stack/os-config-refresh/migration.d

/opt/stack/os-config-refresh is the default base directory. You can set OS_REFRESH_CONFIG_BASE_DIR environment variable to override the default one.

Its intended purpose is to separate scripts execution into 4 phases:

  1. Quiesce(pre-configure.d),
  2. Configure(configure.d),
  3. Activate(post-configure.d).
  4. Migrate(migration.d),

It runs through all the phases above to ensure configuration is applied and enabled on a machine. It will exit with an error if any phase has a problem. The scripts in each phase should not depend on each other having worked properly.

Note: Earlier versions of os-refresh-config ran migration before post-configure. This was an oversight in the initial design, as migrations are intended to be online migrations after the host is fully configured.

For things which must happen while the service is quiesced, that should be done in the post-configure scripts which control the service state.

 
File Type Py Version Uploaded on Size
os-refresh-config-0.1.0.tar.gz (md5) Source 2014-02-24 8KB
  • Downloads (All Versions):
  • 28 downloads in the last day
  • 638 downloads in the last week
  • 4526 downloads in the last month