skip to navigation
skip to content

project_name 0.2.175

This a project template including a setup and the generation of sphinx generation. The documentation generation is using pyquickhelper.



This project is a skeleton for any new project. It contains:

  • a source folder: src
  • a unit test folder: _unittests, go to this folder and run
  • a _doc folder: _doc, it will contains the documentation
  • a file to build and to install the module

All theses steps were only tested on Windows. Suppot for linux will be added later. To create your own project, you need to rename the folder project_name in src by your true module name. You also need to replace project_name wherever it is found:

  • project_var_name¬† = 'project_name' in, and _doc/sphinxdoc/source/
  • from src.project_name.subproject.myexample import myclass in _unittests/ut_example/
  • many places in _doc/sphinxdoc/source/index.rst
  • many places in README.rst

The project is also hosted here where you can find a link to the generated documentation based on this template.


Adding a new module or subpackage

Any new module or subpackage should be added in src/project_name. Every subfolder should contain a file If the new file needs an existing submodule, you need to add something like the following:

import os,sys

from ..subproject.myexample import myclass

You should use relative imports as much as possible. To add a module at deeper level than the previous one, you should add relative imports in every along the way.


  • 0.2 - 2016/??/??
    • change: update for pyquickhelper >= 1.4
  • 0.1 - 2016/03/26
    • new: first version
    • fix: the setup does not need the file README.rst anymore
    • add: unit test to check the file README.rst follows the syntax of docutils 0.8 (for pipy)
    • add: add a unit test to run all notebooks offlines
File Type Py Version Uploaded on Size
project_name-0.2.175-py3-none-any.whl (md5) Python Wheel 3.4 2016-03-27 9KB
project_name-0.2.175.tar.gz (md5) Source 2016-03-27 6KB