wiringpi2 2.32.0

#WiringPi 2 for Python

WiringPi: An implementation of most of the Arduino Wiring

functions for the Raspberry Pi

WiringPi version 2 implements new functions for managing IO expanders.

##Testing Build with gcc version 4.6.3 (Debian 4.6.3-14+rpi1) Built against Python 2.7.2, Python 3.2.3

##Prerequisites You must have python-dev and python-setuptools installed If you manually rebuild the bindings with swig -python wiringpi.i

YOU MUST FIRST INSTALL WIRINGPI2!! `bash git clone git://git.drogon.net/wiringPi cd wiringPi sudo ./build `

##Get/setup repo `bash git clone https://github.com/WiringPi/WiringPi-Python.git cd WiringPi-Python `

##Generate Bindings swig3.0 -thread -python wiringpi.i

##Build & install with sudo python setup.py install

Or Python 3: sudo python3 setup.py install

#Class-based Usage Description incoming!

##Usage

import wiringpi2

wiringpi2.wiringPiSetup() # For sequential pin numbering, one of these MUST be called before using IO functions # OR wiringpi2.wiringPiSetupSys() # For /sys/class/gpio with GPIO pin numbering # OR wiringpi2.wiringPiSetupGpio() # For GPIO pin numbering

Setting up IO expanders (This example was tested on a quick2wire board with one digital IO expansion board connected via I2C):

wiringpi2.mcp23017Setup(65,0x20) wiringpi2.pinMode(65,1) wiringpi2.digitalWrite(65,1)

General IO:

wiringpi2.pinMode(6,1) # Set pin 6 to 1 ( OUTPUT ) wiringpi2.digitalWrite(6,1) # Write 1 ( HIGH ) to pin 6 wiringpi2.digitalRead(6) # Read pin 6

Setting up a peripheral: WiringPi2 supports expanding your range of available “pins” by setting up a port expander. The implementation details of your port expander will be handled transparently, and you can write to the additional pins ( starting from PIN_OFFSET >= 64 ) as if they were normal pins on the Pi.

wiringpi2.mcp23017Setup(PIN_OFFSET,I2C_ADDR)

Soft Tone

Hook a speaker up to your Pi and generate music with softTone. Also useful for generating frequencies for other uses such as modulating A/C.

wiringpi2.softToneCreate(PIN) wiringpi2.softToneWrite(PIN,FREQUENCY)

Bit shifting:

wiringpi2.shiftOut(1,2,0,123) # Shift out 123 (b1110110, byte 0-255) to data pin 1, clock pin 2

Serial:

serial = wiringpi2.serialOpen(‘/dev/ttyAMA0’,9600) # Requires device/baud and returns an ID wiringpi2.serialPuts(serial,”hello”) wiringpi2.serialClose(serial) # Pass in ID

Full details at: http://www.wiringpi.com